Cabinet Painting Client Responsibilities
PRIOR TO ARRIVAL

• Client must remove all belongings from counter tops, floors, and appliances leaving a free and clear work space until job completion. Items may typically stay within the drawers.
• All items inside cabinets must be cleared unless otherwise discussed.
• Any items to be used during a the typical work day should be repositioned to another room for easier access.

Please Take Note!

Client is responsible for moving refrigerator and/or stove if painting around them is required.

Our Cabinet Painting & Refinishing Process

PREP INTERIOR:

• All areas within immediate workspace will be covered using plastic, tape, paper and/or drop cloths to lessen any risk of paint splatter or overspray. A filtered exhaust fan will be positioned inside kitchen and vented outside of workspace.
• Doors and drawers will be sprayed off-site at Colorworx Painting LLC's shop located at 5851 Cypress Hill Road. This timeframe shoud not exceedd 10 days in a typical scope of most projects.
• Remove and label all cabinet hardwrae and hinges
• Remove and label all cabinet doors and drawers.
• Degrease all cabinet bases/boxes, doors, and drawer fronts.
• De-gloss / scuff / sand all cabinet bases/boxes, doors, and drawer fronts.
• All sanding is done using dustless sanding systems by Surfprep and Festool.
• Prime all cabinet bases/boxes, doors, and drawers using KCMA approved stain blocking primer / bonding primer for proper adhesion.

PAINTING PROCESS:

• All cabinet drawers will be sprayed off-site with a KCMA rated coating using HVLP / airless / air assist application to MFG specification to provide a superior factory finish.
• Paint application: cabinet bases / boxes island / trim.
• All bases, "boxes", island, and trim will be sprayed using HVLP / airless / air assist after proper prep has been achieved.

CABINET INSTALLATION:

• All cabinet doors and drawers will be installed after all masking is removed and bases / boxes have property dried.
• New cabinet bumpers will be installed, all doors will be properly aligned, all hardware will be (re)installed.
• Soft-clse or new hardware will be installed at separate cost or after being discussed.

FINAL PROCESS:

• Remove all plastic, tape, paper from all areas and dispose of off-site.
• Reposition any items that were previously moved (if discussed and to be moved by CWP.)
• Final walk-thru client.